![]() To me, a memory of the previous metering is unnecessary, I’d much rather just meter immediately from sleep. Not much of a nitpick but just something to be wary of. You will have to push it again to get a current reading. When you wake it from sleep by pressing the meter button, the screen will show the previous exposure. I can not comment on battery too much since I have not used it till it drained but it has lasted over a week of shooting everyday without a battery warning. Perhaps this was addressed in the latest version. I’ve read about sluggishness issues with the buttons and scrolling but not in the sample I was given. Even when comparing it with the Nikon FM3a’s meter, the Keks readings remain within 1/3rd of a stop. When I say “virtually,” I mean if the VC says f2 at 1/60th, the Keks might say f2 at 1/50th. Autumn in Japan gives you such mixed lighting that it served as a good test. In metering accuracy, the Keks EM-01 light meter performed virtually identical to the Voigtlander VC II. The Keks does and while not ideal, the screen can still be read at this angle The Voigtlander VC II will not fit on my beloved Rolleiflex SL66. To me, the latter is a more efficient and intuitive process. Whereas with the Keks you can frame your shot, activate the light meter then look up to see the reading then set your exposure accordingly and fire. With the VC II, you have to point it in the direction of your shot and have it where you can look over it to adjust the dials to make sure you get the “red circle” of correct exposure, set your camera then compose and shoot. Personally, this difference forces me to meter in a different way. The readings are displayed on the top of the meter as opposed to the back screen of the Keks. The Voigtlander has no screens and opts for old school physical dials instead of the button system of the Keks. The Keks and the Voigtlander are the same width, but the Keks is 1mm taller, 9mm shorter and weighs 3g less. Here is a look at the Keks EM-01 against the Voigtlander VC II side by side. On the bottom too you will find the USB-C charging port. It comes with an assortment of larger and smaller mounts to fit any camera, as well as you are able to position the mount in the center or to the side of the bottom of the meter (3 positions) using the provided hex key. What’s in the boxĪny camera with a hot/cold shoe can use the Keks EM-01. To set the ISO, hold the button on the back of the unit next to the screen and then press either up or down on the aperture adjustment. With the meter facing up, the left side buttons adjust the aperture and the right side adjusts the shutter speed just as with the Voigtlander VC meter. On the aluminum top plate, 4 buttons control the aperture and shutter speed. There’s a battery status indicator as well, which flashes when the battery is low and stops flashing when the meter is fully charged. The display will automatically adjust the brightness in different environments. There are also two selectable metering mode, the aperture priority mode and shutter speed priority mode. The OLED display shows the shutter speed, aperture, ISO, EV, and LUX reading. #BRONICA S2 EXPOSURE METER MANUAL#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |